How to Cut Crown Molding Without a Compound Miter Saw
- 1). Determine the dimensions of the crown molding using your measuring tape. Get the exact length that you need to cut and jot it down on a piece of paper.
- 2). Place a piece of the crown molding next to your ceiling using your hands to determine the exact surfaces of the molding that will come in contact with the ceiling or wall. Normally, crown moldings with 45-degree edges are the ones that easily make contact with the wall. For trim or baseboards, they use the flat surface on the back.
- 3). Cut the crown molding using your table saw, holding the board against it with an angle of 45 degrees on its edges. Allow the edges to touch the guide as well as the table top in the same position it would have when linked to the ceiling or wall.
- 4). Stand to the side of the table saw and plant your feet firmly on the floor. Push the crown molding into the saw's blade while applying little pressure. Keep your hands away from the blade by using a push stick while handling the table saw.
- 5). Press the crown molding against the guide as you cut it according to the exact degrees. Remove the crown molding from the saw as soon the blade stops spinning.
Source...